Support service
Search
Send message
Find your message
DiamCalc
Oxygen
Helium Polish
Helium Rough & Pacor
Helium Rough & Pacor
3DCalc family
Oxygen
Helium Polish
Helium Rough & Pacor
 

FAQ

  DiamCalc Oxygen Helium Polish Helium Rough & Pacor

DiamCalc questions page 1page 2

 

  previous   top   next

What is the difference between DLL cut and cut made with Cut Designer?

The main difference in the behaviour of resulting cut in DiamCalc:

  • The Cut Designer cut finally has the parameters which describe the properties of every facet layer which are not always correspond to any desired standard cut parameters, like Crown height, Star facet length etc
  • DLL cut has the set of desired parameters which are usually defined at the stage of project and extra desired parameters may be implemented later by a software engineer, so the parameters of DLL cut are more appropriate and convenient for later adjustments - especially via the automated parameter adjustments within predefined ranges as you can prescribe in DiamCalc Pro

  previous   top   next